怘€æ€˜€`3f<€fÀæøÀ̆ž?`??f?æžf<øž`??ð3ž<3ž<`/interrupt-affinity[0] [ 1.178283] hw perfevents: enabled with armv7_cortex_a8 PMU driver, 5 counters available [ 1.190093] futex hash table entries: 256 (order: 2, 16384 bytes) [ 1.190582] audit: initializing netlink subsys (disabled) [ 1.191070] audit: type=2000 audit(1.220:1): initialized [ 1.200317] VFS: Disk quotas dquot_6.6.0 [ 1.200592] VFS: Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) [ 1.206512] NFS: Registering the id_resolver key type [ 1.207336] Key type id_resolver registered [ 1.207366] Key type id_legacy registered [ 1.207733] jffs2: version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. [ 1.218261] io scheduler noop registered [ 1.218322] io scheduler deadline registered [ 1.218414] io scheduler cfq registered (default) [ 1.223724] pinctrl-single 48002030.pinmux: 284 pins at pa fa002030 size 568 [ 1.225097] pinctrl-single 48002a00.pinmux: 46 pins at pa fa002a00 size 92 [ 1.226928] pinctrl-single 480025d8.pinmux: 18 pins at pa fa0025d8 size 36 [ 1.235321] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled [ 1.249267] omap_uart 4806a000.serial: no wakeirq for uart0 [ 1.250396] 4806a000.serial: ttyO0 at MMIO 0x4806a000 (irq = 88, base_baud = 3000000) is a OMAP UART0 [ 1.254730] omap_uart 4806c000.serial: no wakeirq for uart1 [ 1.255340] 4806c000.serial: ttyO1 at MMIO 0x4806c000 (irq = 89, base_baud = 3000000) is a OMAP UART1 [ 1.259094] 49020000.serial: ttyO2 at MMIO 0x49020000 (irq = 90, base_baud = 3000000) is a OMAP UART2 [ 1.669219] console [ttyO2] enabled [ 1.737060] brd: module loaded [ 1.777313] loop: module loaded [ 1.797027] twl 0-0048: PIH (irq 23) chaining IRQs 307..315 [ 1.800811] twl 0-0048: power (irq 312) chaining IRQs 315..322 [ 1.890106] twl4030_gpio twl4030-gpio: gpio (irq 307) chaining IRQs 323..340 [ 1.910949] mtdoops: mtd device (mtddev=name/number) must be supplied [ 1.918029] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xba [ 1.921508] nand: Micron MT29F2G16ABD [ 1.923553] nand: 256 MiB, SLC, erase size: 128 KiB, page size: 2048, OOB size: 64 [ 1.927795] nand: using OMAP_ECC_HAM1_CODE_HW [ 1.930389] 5 ofpart partitions found on MTD device omap2-nand.0 [ 1.933685] Creating 5 MTD partitions on "omap2-nand.0": [ 1.936676] 0x000000000000-0x000000080000 : "X-Loader" [ 1.950988] 0x000000080000-0x000000260000 : "U-Boot" [ 1.961761] 0x000000260000-0x000000280000 : "U-Boot Env" [ 1.971069] 0x000000280000-0x000000680000 : "Kernel" [ 1.983795] 0x000000680000-0x000010000000 : "Filesystem" [ 2.231506] mousedev: PS/2 mouse device common for all mice [ 2.234771] i2c /dev entries driver [ 2.295501] ledtrig-cpu: registered to indicate activity on CPUs [ 2.301635] oprofile: using arm/armv7 [ 2.305419] Initializing XFRM netlink socket [ 2.308044] NET: Registered protocol family 17 [ 2.310638] NET: Registered protocol family 15 [ 2.313995] Key type dns_resolver registered [ 2.316894] omap2_set_init_voltage: unable to find boot up OPP for vdd_mpu_iva [ 2.320770] omap2_set_init_voltage: unable to set vdd_mpu_iva [ 2.324005] omap2_set_init_voltage: unable to find boot up OPP for vdd_core [ 2.327789] omap2_set_init_voltage: unable to set vdd_core [ 2.334869] PM: no software I/O chain control; some wakeups may be lost [ 2.341918] ThumbEE CPU extension supported. [ 2.344451] Registering SWP/SWPB emulation handler [ 2.347076] SmartReflex Class3 initialized [ 2.389678] hctosys: unable to open rtc device (rtc0) [ 2.392456] sr_init: No PMIC hook to init smartreflex [ 2.396240] smartreflex smartreflex.0: omap_sr_probe: SmartReflex driver initialized [ 2.400878] smartreflex smartreflex.0: omap_sr_probe: smartreflex_mpu_iva: No Voltage table for the corresponding vdd. Cannot create debugfs entries for n-values [ 2.409545] smartreflex: probe of smartreflex.0 failed with error -61 [ 2.413391] smartreflex smartreflex.1: omap_sr_probe: SmartReflex driver initialized [ 2.417999] smartreflex smartreflex.1: omap_sr_probe: smartreflex_core: No Voltage table for the corresponding vdd. Cannot create debugfs entries for n-values [ 2.426239] smartreflex: probe of smartreflex.1 failed with error -61 [ 2.429992] sr_init: platform driver register failed for SR [ 2.547485] hsusb2_vbus: disabling [ 2.550842] VUSB3V1: disabling [ 2.554138] VUSB1V8: disabling [ 2.556945] VUSB1V5: disabling [ 2.560119] VDAC: disabling [ 2.563171] VAUX3: disabling [ 2.573364] Waiting for root device /dev/mmcblk0p2... [ 2.586639] mmc0: host does not support reading read-only switch, assuming write-enable [ 2.591339] mmc0: new SD card at address 8001 [ 2.598205] mmcblk0: mmc0:8001 SD02G 1.89 GiB [ 2.609863] mmcblk0: p1 p2 [ 3.810546] kjournald starting. Commit interval 5 seconds [ 3.814422] EXT3-fs (mmcblk0p2): warning: maximal mount count reached, running e2fsck is recommended [ 3.999023] EXT3-fs (mmcblk0p2): using internal journal [ 4.007659] EXT3-fs (mmcblk0p2): recovery complete [ 4.010284] EXT3-fs (mmcblk0p2): mounted filesystem with ordered data mode [ 4.014404] VFS: Mounted root (ext3 filesystem) on device 179:2. [ 4.025390] devtmpfs: mounted [ 4.028778] Freeing unused kernel memory: 440K (c0838000 - c08a6000) INIT: version 2.86 booting Starting the hotplug events dispatcher udevd [ 5.605194] udevd (90): /proc/90/oom_adj is deprecated, please use /proc/90/oom_score_adj instead. Synthesizing the initial hotplug events [ 21.040527] FAT-fs (mmcblk0p1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck. Remounting root file system... mount: according to mtab, /proc is already mounted on /proc WARNING: Couldn't open directory /lib/modules/4.1.0-rc1-142160-ga5bf00c: No such file or directory FATAL: Could not open /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep.temp for writing: No such file or directory root: mount: mount point /proc/bus/usb does not exist Setting up IP spoofing protection: rp_filter. Configuring network interfaces... modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory ifconfig: SIOCGIFFLAGS: No such device modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory eth0 No such device modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory udhcpc: SIOCGIFINDEX: No such device done. Starting portmap daemon: portmap. %% Start PM consolidated quick test %% Preparation hwclock: can't open '/dev/misc/rtc': No such file or directory Tue Jul 22 00:18:00 UTC 2008 hwclock: can't open '/dev/misc/rtc': No such file or directory INIT: Entering runlevel: 5 ALSA: Restoring mixer settings... /usr/sbin/alsactl: load_state:1327: No soundcards found... Starting Dropbear SSH server: modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory dropbear. Starting advanced power management daemon: No APM support in kernel (failed.) Starting system message bus: dbus. Starting syslogd/klogd: start-stop-daemon: lseek: Invalid argument * Starting Avahi mDNS/DNS-SD Daemon: avahi-daemon [ ok ] Starting Bluetooth subsystem: hcidmodprobe: FATAL: Could not load /lib/modules/4.1.0-rc1-142160-ga5bf00c/modules.dep: No such file or directory hid2hci. .-------. | | .-. | | |-----.-----.-----.| | .----..-----.-----. | | | __ | ---'| '--.| .-'| | | | | | | | |--- || --'| | | ' | | | | '---'---'--'--'--. |-----''----''--' '-----'-'-'-' -' | '---' The Angstrom Distribution beagleboard ttyO2 Angstrom 2008.1-test-20080712 beagleboard ttyO2 beagleboard login: