CCCSending /srv/serial/u-boot-spl.bin, 784 blocks: Give your local XMODEM receive command now.

Transfer complete
t SPL 2013.04-00235-g48e0b2b (May 18 2013 - 18:06:38)
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 47401000 using PIO, IRQ 0
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Host mode controller at 47401800 using PIO, IRQ 0
CSending: u-boot.bin
Sending: 

Transfer complete
m - CRC mode, 3(SOH)/375(STX)/0(CAN) packets, 3 retries
Loaded 384084 bytes


U-Boot 2013.04-00235-g48e0b2b (May 18 2013 - 18:06:38)

I2C:   ready
DRAM:  256 MiB
WARNING: Caches not enabled
NAND:  No NAND device found!!!
0 MiB
MMC:   OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - readenv() failed, using default environment

musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 47401000 using PIO, IRQ 0
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Host mode controller at 47401800 using PIO, IRQ 0
Net:   <ethaddr> not set. Validating first E-fuse MAC
cpsw, usb_ether
Hit any key to stop autoboot:  1  0 
U-Boot# 
U-Boot# setenv autoload off; setenv serverip 192.168.57.1; dhcp
cpsw Waiting for PHY auto negotiation to complete. done
link up on port 0, speed 100, full duplex
BOOTP broadcast 1
DHCP client bound to address 192.168.57.138
U-Boot# tftp 0x81000000 zImage.omap2plus_defconfig
link up on port 0, speed 100, full duplex
Using cpsw device
TFTP from server 192.168.57.1; our IP address is 192.168.57.138
Filename 'zImage.omap2plus_defconfig'.
Load address: 0x81000000
Loading: *#################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #####################################
	 1 MiB/s
done
Bytes transferred = 4359232 (428440 hex)
U-Boot# tftp 0x82000000 am335x-boneblack.dtb
link up on port 0, speed 100, full duplex
Using cpsw device
TFTP from server 192.168.57.1; our IP address is 192.168.57.138
Filename 'am335x-boneblack.dtb'.
Load address: 0x82000000
Loading: *#
	 729.5 KiB/s
done
Bytes transferred = 10462 (28de hex)
U-Boot# setenv bootargs console=ttyO0,115200n8 rw debug ignore_loglevel earlyprintk root=/dev/nfs nfsroot=192.168.57.1:/srv/nfs4/rootfs2 nfsrootdebug ip=dhcp
U-Boot# 
U-Boot# bootz 0x81000000 - 0x82000000
## Flattened Device Tree blob at 82000000
   Booting using the fdt blob at 0x82000000
   Using Device Tree in place at 82000000, end 820058dd

Starting kernel ...