怘€æ€˜€`3f<€fÀæøÀ̆ž?`??f?æžf<øž`??ð3ž<3ž<`/interrupt-affinity[0] [ 1.178070] hw perfevents: enabled with armv7_cortex_a8 PMU driver, 5 counters available [ 1.189758] futex hash table entries: 256 (order: 2, 16384 bytes) [ 1.190246] audit: initializing netlink subsys (disabled) [ 1.190734] audit: type=2000 audit(1.160:1): initialized [ 1.200012] VFS: Disk quotas dquot_6.6.0 [ 1.200286] VFS: Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) [ 1.205688] NFS: Registering the id_resolver key type [ 1.206512] Key type id_resolver registered [ 1.206542] Key type id_legacy registered [ 1.206939] jffs2: version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. [ 1.217864] io scheduler noop registered [ 1.217926] io scheduler deadline registered [ 1.218017] io scheduler cfq registered (default) [ 1.223358] pinctrl-single 48002030.pinmux: 284 pins at pa fa002030 size 568 [ 1.224456] pinctrl-single 48002a00.pinmux: 46 pins at pa fa002a00 size 92 [ 1.226287] pinctrl-single 480025d8.pinmux: 18 pins at pa fa0025d8 size 36 [ 1.234893] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled [ 1.248992] omap_uart 4806a000.serial: no wakeirq for uart0 [ 1.250122] 4806a000.serial: ttyO0 at MMIO 0x4806a000 (irq = 88, base_baud = 3000000) is a OMAP UART0 [ 1.254089] omap_uart 4806c000.serial: no wakeirq for uart1 [ 1.254699] 4806c000.serial: ttyO1 at MMIO 0x4806c000 (irq = 89, base_baud = 3000000) is a OMAP UART1 [ 1.258575] 49020000.serial: ttyO2 at MMIO 0x49020000 (irq = 90, base_baud = 3000000) is a OMAP UART2 [ 1.666198] console [ttyO2] enabled [ 1.732208] brd: module loaded [ 1.771423] loop: module loaded [ 1.790954] twl 0-0048: PIH (irq 23) chaining IRQs 307..315 [ 1.794708] twl 0-0048: power (irq 312) chaining IRQs 315..322 [ 1.883270] twl4030_gpio twl4030-gpio: gpio (irq 307) chaining IRQs 323..340 [ 1.904144] mtdoops: mtd device (mtddev=name/number) must be supplied [ 1.911254] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xbc [ 1.914733] nand: Micron MT29F4G16ABBDA3W [ 1.916900] nand: 512 MiB, SLC, erase size: 128 KiB, page size: 2048, OOB size: 64 [ 1.921142] nand: using OMAP_ECC_HAM1_CODE_HW [ 1.923553] nand: WARNING: omap2-nand.0: the ECC used on your system is too weak compared to the one required by the NAND chip [ 1.929962] 5 ofpart partitions found on MTD device omap2-nand.0 [ 1.933227] Creating 5 MTD partitions on "omap2-nand.0": [ 1.936126] 0x000000000000-0x000000080000 : "X-Loader" [ 1.950378] 0x000000080000-0x000000260000 : "U-Boot" [ 1.961120] 0x000000260000-0x000000280000 : "U-Boot Env" [ 1.970397] 0x000000280000-0x000000680000 : "Kernel" [ 1.983215] 0x000000680000-0x000010000000 : "Filesystem" [ 2.245941] mousedev: PS/2 mouse device common for all mice [ 2.249206] i2c /dev entries driver [ 2.309051] ledtrig-cpu: registered to indicate activity on CPUs [ 2.315216] oprofile: using arm/armv7 [ 2.318908] Initializing XFRM netlink socket [ 2.321563] NET: Registered protocol family 17 [ 2.324127] NET: Registered protocol family 15 [ 2.327484] Key type dns_resolver registered [ 2.330322] omap2_set_init_voltage: unable to find boot up OPP for vdd_mpu_iva [ 2.334259] omap2_set_init_voltage: unable to set vdd_mpu_iva [ 2.337524] omap2_set_init_voltage: unable to find boot up OPP for vdd_core [ 2.341308] omap2_set_init_voltage: unable to set vdd_core [ 2.351623] ThumbEE CPU extension supported. [ 2.354034] Registering SWP/SWPB emulation handler [ 2.356658] SmartReflex Class3 initialized [ 2.399597] hctosys: unable to open rtc device (rtc0) [ 2.402374] sr_init: No PMIC hook to init smartreflex [ 2.405914] smartreflex smartreflex.0: omap_sr_probe: SmartReflex driver initialized [ 2.411712] smartreflex smartreflex.1: omap_sr_probe: SmartReflex driver initialized [ 2.530761] hsusb2_vbus: disabling [ 2.534179] VUSB3V1: disabling [ 2.537261] VUSB1V8: disabling [ 2.540039] VUSB1V5: disabling [ 2.543212] VDAC: disabling [ 2.546264] VAUX3: disabling [ 2.556243] Waiting for root device /dev/mmcblk0p2... [ 2.569793] mmc0: host does not support reading read-only switch, assuming write-enable [ 2.574493] mmc0: new SD card at address e624 [ 2.581512] mmcblk0: mmc0:e624 SD01G 968 MiB [ 2.593749] mmcblk0: p1 p2 [ 3.093383] kjournald starting. Commit interval 5 seconds [ 3.103851] EXT3-fs (mmcblk0p2): using internal journal [ 3.200531] EXT3-fs (mmcblk0p2): recovery complete [ 3.203186] EXT3-fs (mmcblk0p2): mounted filesystem with ordered data mode [ 3.207244] VFS: Mounted root (ext3 filesystem) on device 179:2. [ 3.216308] devtmpfs: mounted [ 3.219818] Freeing unused kernel memory: 440K (c0838000 - c08a6000) INIT: version 2.86 booting Starting the hotplug events dispatcher udevd [ 4.728363] udevd (90): /proc/90/oom_adj is deprecated, please use /proc/90/oom_score_adj instead. Synthesizing the initial hotplug events [ 19.676574] FAT-fs (mmcblk0p1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck. Remounting root file system... mount: according to mtab, /proc is already mounted on /proc WARNING: Couldn't open directory /lib/modules/4.1.0-rc2-12071-g5ebe6af: No such file or directory FATAL: Could not open /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep.temp for writing: No such file or directory root: mount: mount point /proc/bus/usb does not exist Setting up IP spoofing protection: rp_filter. Configuring network interfaces... modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory ifconfig: SIOCGIFFLAGS: No such device modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory eth0 No such device modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory udhcpc: SIOCGIFINDEX: No such device done. Starting portmap daemon: portmap. hwclock: can't open '/dev/misc/rtc': No such file or directory %% Start PM consolidated quick test %% Preparation INIT: Entering runlevel: 5 ALSA: Restoring mixer settings... /usr/sbin/alsactl: load_state:1327: No soundcards found... Starting Dropbear SSH server: [ 31.752380] random: dropbear urandom read with 101 bits of entropy available modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory modprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory dropbear. Starting advanced power management daemon: No APM support in kernel (failed.) Starting system message bus: dbus. Starting syslogd/klogd: start-stop-daemon: lseek: Invalid argument * Starting Avahi mDNS/DNS-SD Daemon: avahi-daemon [ ok ] Starting Bluetooth subsystem: hcidmodprobe: FATAL: Could not load /lib/modules/4.1.0-rc2-12071-g5ebe6af/modules.dep: No such file or directory hid2hci. .-------. | | .-. | | |-----.-----.-----.| | .----..-----.-----. | | | __ | ---'| '--.| .-'| | | | | | | | |--- || --'| | | ' | | | | '---'---'--'--'--. |-----''----''--' '-----'-'-'-' -' | '---' The Angstrom Distribution beagleboard ttyO2 Angstrom 2008.1-test-20080712 beagleboard ttyO2 beagleboard login: